SEK 0,00
(fraktkostnad: 0,00)
Black Box PP-SC-50MM-6PAK, SC, SC
Art.nr.: [4746700] | Tillverkare: Black box | Modell-nr.: PP-SC-50MM-6PAK
Varan finns inte i lager
Varan finns inte i lager. Mer info
Fri frakt Instabox - Närmaste Paketbox
Se alla alternativ
| Instabox - Välj själv paketbox | Gratis |
| Bring - Närmaste utlämningställe | Gratis |
| Budbee - Hemleverans - Levereras på eftermiddagen eller kvällen. | 129,00 |
| Bring - Hemleverans - Levereras till din dörr på vardagar mellan 08:00 och 16:00. | 135,00 |
Slutsåld
Varan finns inte i lager.
SEK
1.213,61
ex. moms 970,89
Totalt inkl. frakt
1.213,61
Meddela mig när varan åter finns i lager
Funktionen kräver att man är inloggad. Skapa en användare och gör bruk av vårt smarta listsystem till att hålla koll på framtidiga köp, regelbundna köp eller önskelistor.
Skapa användare
Login
Skapa användare
Login
Send på mail
This Pre-Polished Fiber Optic Connector can save technicans a ton of time in the field. These connectors are so easy to install, you can do it in a minute! There's no hand polishing. No epoxy!
Proven mechanical splice technology ensures precise fiber alignment. A factory pre-cleaved, factory-polished ferrule couples to the fiber being terminated with precise mechanical alignment. A proprietary index-matching gel ensures a low loss termination to a single-mode fiber cable. There are no expensive tools, no messy epoxy needed.
A factory-installed wedge clip holds the clamping device open while the fiber is inserted. This clip also enables the use of a Visible Fault Identifier (VFI) to provide a "pass/fail" signal once physical contact is achieved. The connector is compatible with 250-µm and 900-µm optical fibers, as well as 900-µm cable. A 900-µm boot is provided with each connector.
This connector is also available in ST and LC versions and for both single-mode and 62.5-micron multimode fiber, as well as for OM3 laser-optimized multimode fiber. Connectors for each fiber type are color coded to industry standard requirements to help with identification during and after installation.
Proven mechanical splice technology ensures precise fiber alignment. A factory pre-cleaved, factory-polished ferrule couples to the fiber being terminated with precise mechanical alignment. A proprietary index-matching gel ensures a low loss termination to a single-mode fiber cable. There are no expensive tools, no messy epoxy needed.
A factory-installed wedge clip holds the clamping device open while the fiber is inserted. This clip also enables the use of a Visible Fault Identifier (VFI) to provide a "pass/fail" signal once physical contact is achieved. The connector is compatible with 250-µm and 900-µm optical fibers, as well as 900-µm cable. A 900-µm boot is provided with each connector.
This connector is also available in ST and LC versions and for both single-mode and 62.5-micron multimode fiber, as well as for OM3 laser-optimized multimode fiber. Connectors for each fiber type are color coded to industry standard requirements to help with identification during and after installation.