SEK 0,00
(fraktkostnad: 0,00)
Adafruit 1602, Peksensor, Adafruit, 42 mm, 18 mm, 2,5 g
Art.nr.: [7410500] | Tillverkare: Adafruit | Modell-nr.: 1602 | EAN: 2050004691146
Fjärrlager (4-5 arbetsdagar)
Varan finns i vårt fjärrlager, leveranstiden är 4-5 arbetsdagar. Mer info
Frakt 49,00 - Instabox - Välj själv närmaste paketbox
Se alla alternativ
| Instabox - Välj själv paketbox | 49,00 |
| Bring - Närmaste utlämningställe | 49,00 |
| Budbee - Hemleverans - Levereras på eftermiddagen eller kvällen. | 69,00 |
| Bring - Hemleverans - Levereras till din dörr på vardagar mellan 08:00 och 16:00. | 135,00 |
SEK
237,00
ex. moms 189,60
Totalt inkl. frakt
286,00
Funktionen kräver att man är inloggad. Skapa en användare och gör bruk av vårt smarta listsystem till att hålla koll på framtidiga köp, regelbundna köp eller önskelistor.
Skapa användare
Login
Skapa användare
Login
Send på mail
Add lots of touch sensors to your next microcontroller project with this easy-to-use 8-channel capacitive touch sensor breakout board, starring the CAP1188. This chip can handle up to 8 individual touch pads, and has a very nice feature that makes it stand out for us: it will light up the 8 onboard LEDs when the matching touch sensor fires to help you debug your sensor setup.
The CAP1188 has support for both I2C and SPI, so it easy to use with any microcontroller. If you are using I2C, you can select one of 5 addresses, for a total of 40 capacitive touch pads on one I2C 2-wire bus. Using this chip is a lot easier than doing the capacitive sensing with analog inputs: it handles all the filtering for you and can be configured for more/less sensitivity.
Comes with a fully assembled board, and a stick of 0.1" header so you can plug it into a breadboard. For contacts, we suggest using copper foil, then solder a wire that connects from the foil pad to the breakout.
The CAP1188 has support for both I2C and SPI, so it easy to use with any microcontroller. If you are using I2C, you can select one of 5 addresses, for a total of 40 capacitive touch pads on one I2C 2-wire bus. Using this chip is a lot easier than doing the capacitive sensing with analog inputs: it handles all the filtering for you and can be configured for more/less sensitivity.
Comes with a fully assembled board, and a stick of 0.1" header so you can plug it into a breadboard. For contacts, we suggest using copper foil, then solder a wire that connects from the foil pad to the breakout.